Transfer Instructions

Screen Print Transfer Heat Press Instructions:  

• Set your heat press to 325-350°F, adjusting as needed for your machine. 
• Pre-press your garment for a few seconds to remove any moisture.
•  Position the transfer and press with MAXIMUM pressure for 15 seconds.Gently peel while HOT for best results.
• If the transfer is not fully adhered, press again for 2-3 seconds.

Direct To Film (DTF) Heat Press Instructions

Heat Press Instructions – Cool Peel + Re-Press

• Temperature: 300°F (150°C)
  – For thicker garments or colder environments, increase to 325°F–335°F.

• Press Time: 10–15 seconds
  – For thicker fabrics or cold conditions, press for 20–25 seconds.

• Peeling Method: Cool Peel
  – Allow the transfer to cool before peeling the film.
  – After peeling, re-press for 5–10 seconds with a Teflon sheet or parchment paper to seal the design.

Washing & Drying Care:

• Wait at least 72 hours before first wash.

• Do NOT use hot water.

• Tumble dry at low heat (max 220°F) or hang to dry.

• Avoid washer/dryer combo machines as they may wrinkle or damage the transfer.

Sublimation paper Clip Instructions

Press at (356°F) for 70 seconds to achieve crisp, clear images without distortion. Allow the clips to cool completely before handling to prevent burns or warping.

TAKE NOTE: 

ALL TRANSFERS REQUIRE HEAVY PRESSURE!

- Home irons, Cricut Easy Presses, or similar devices do not provide the necessary pressure and may result in poor adhesion of the print.

- For optimal results, please use a commercial heat press to ensure accurate pressure and the best quality.

- Refunds will not be issued for prints that were not pressed correctly.